SOL: 1
Name of person filing report: Nathan Bitner
Non-nominal systems: None
ROVERS
Spirit rover used: Yes
Hours: 239.6
Beginning charge: 100%
Ending charge: 72%
Currently charging: Yes
Opportunity rover used: Yes
Hours: 152.3
Beginning charge: 100%
Ending charge: 90%
Currently charging: Yes
Curiosity rover used: No
Hours: N/A
Beginning charge: N/A
Ending charge: N/A
Currently charging: Yes
Perseverance rover used: No
Hours: N/A
Beginning charge: N/A
Ending charge: N/A
Currently charging: Yes
General notes on rovers: Rovers are functioning properly.
Summary of Hab operations:
WATER USE: first day of sim, did not measure previous day use
Water (static tank): 498 gallons
Static tank pipe heater (on or off): On
Static tank heater (on or off): On
Toilet tank emptied: No
Summary of internet: Internet is nominal.
Summary of suits and radios: Suits and radios are nominal.
Summary of GreenHab operations:
WATER USE: 4.15 gallons (Sol 0 and 1)
Heater: On
Supplemental light: On
Harvest:
Lettuce – 18 g ( Sol 0)
Kale – 95 g
Cilantro – 4 g
Arugula- 12 g
Summary of ScienceDome operations: Prepped hydroponics setup for research project, didn’t use major equipment.
Dual split: Heat or AC: Heat
Summary of RAM operations: (Tools used, work done): No work was conducted in RAM. A multimeter was removed for future EVA charge testing Measuring tape for measuring water level. Two Phillips screwdrivers were also removed for reattaching a loose screw from EVA suit 11. None of these have yet been returned.
Summary of any observatory issues: All systems are nominal.
Summary of health and safety issues: No health or safety issues.
Questions, concerns and requests to Mission Support:
Can we move the humidifier from the upper hab to the greenhouse?
Does the science dome fan consume too much power to run all the time?
The Greenhab supplemental light was used temporarily in the day, does that constitute a Yes under greenhab operations on this form?
For this report I used the current charge status of the rovers, but we did not plug it in immediately after use. Should we use whether we plugged it in or current status?